REV Rides Support provides the quickest access to our support experts. Shoot us an email here to get started.

Sometimes it's best to get on the phone and figure it out. Give us a call!

Back to revrides.com

REV Rides YouTube

REV Rides Support

<div data-block="true" data-editor="fesmm" data-offset-key="a9og6-0-0" id="isPasted"><div data-offset-key="a9og6-0-0"><span data-offset-key="a9og6-0-0"><br data-text="true"></span></div></div><div data-block="true" data-editor="fesmm" data-offset-key="8u8k2-0-0"><div data-offset-key="8u8k2-0-0"><span data-offset-key="8u8k2-0-0"><span data-text="true">Seeing that the voltage is not reading at all, the BMS (battery controlelr) may have shut off from a controller short. Please do the following steps and record your results:</span></span></div></div><div data-block="true" data-editor="fesmm" data-offset-key="98eq7-0-0"><br></div><div data-block="true" data-editor="fesmm" data-offset-key="e1n2l-0-0"><div data-offset-key="e1n2l-0-0">1<span data-offset-key="e1n2l-0-0"><span data-text="true">. Plug the charger into the wall and then into the battery and leave it for a couple minutes. What light does the charger turn?</span></span></div></div><div data-block="true" data-editor="fesmm" data-offset-key="cq5he-0-0"><div data-offset-key="cq5he-0-0"><span data-offset-key="cq5he-0-0"><span data-text="true">2. Assuming the charger does NOT stay completely green (either it turns red or flashes in between colors), charge the battery until it is fully charged.</span></span></div></div><div data-block="true" data-editor="fesmm" data-offset-key="dmafs-0-0"><div data-offset-key="dmafs-0-0"><span data-offset-key="dmafs-0-0"><span data-text="true">3. If the charger light does just stay green, leave the battery for 15 minutes on the charger and then try reading the voltage again</span></span></div></div><div data-block="true" data-editor="fesmm" data-offset-key="63k7c-0-0"><div data-offset-key="63k7c-0-0"><span data-offset-key="63k7c-0-0"><span data-text="true">4. If the charger does charge the battery, please read the voltage again after fully charging the battery.</span></span></div></div>

Seeing that the voltage is not reading at all, the BMS (battery controlelr) may have shut off from a controller short. Please do the following steps and record your results:1. Plug the charger into the wall and then into the battery and leave it for

Battery 0 Volts/device won't turn on reset

General

Device Lubrication

Charger Voltage Check With Multimeter

Wobbly tire - how to reseat your tire

BEGODE GOTWAY 100V charger testing

Begode T4 vibration in motor issue

Begode gotway RS EXN Monster Pro battery pack troubleshooting won't charge charging issues

Begode Gotway wheel unlocking

Begode T4 Rattle Rattling

EUC Tire Changes

Electric Unicycle Troubleshooting and Installation

Battery Check With Multi Meter

How to fix squeaky brakes on eScooter / How to adjust brakes on an eScooter

Brakes not strong enough or too strong

VSETT Throttle / keyswitch / LCD replacement

VSETT 8 Controller Replacement / Unplugging

VSETT 9, 9+, 10+, 11+ Controller Replacement / Unplugging

Electric Scooter brake pads and drums replacement

Brake Sensor adjustments

eScooter Tire and Tube change

What caused my eScooter flat tire?

eScooter P-Settings guide

Electric Scooter Troubleshooting and Installation

EBMX X9000 App Manual

Electric Bike Troubleshooting and Installation

Battery 0 Volts/device won't turn on resetUpdated 4 months ago